Book Read Free

Cheyenne Saturday - Empty-Grave Extended Edition

Page 12

by Richard Jessup


  * * *

  Teams often consisted of twenty Chinese workers and one white foreman, although team size grew for difficult stretches of grading and laying track. Chinese employees earned $30 a month, minus the cost of food and board. The Irish earned $35 a month with board provided at no charge.

  * * *

  Caption 09...Wagon train following behind the builders of the Transcontinental Railroad and responsible for building up settlements along the line.

  Caption 10...Track gang curving rail in Ten-Mile Canyon along the Humbolt River in Nevada, 1867.

  * * *

  Crude methods were employed when track had to be curved. The 56 pound yard iron rail, measuring 32 feet in length, was laid across two railroad ties spaced 25 feet apart. Eight workers would stand on the rail as the hammer-man struck with a heavy sledge. The weight of the men provided just enough spring to bend the rail slightly. The position of hammer-man required great skill and strength. They were responsible for measuring the curves by sight and determining where a strike was needed to balance the rail.

  * * *

  Bad weather was a continuing challenge. The winter of 1866 brought forty-four snowstorms, avalanches, and—for the crews tunneling through mountains—the excruciating job of clearing ice and rubble at the entry point. The snow pack at the top of the Sierra Nevadas could reach a depth of eighteen feet. Camp 4, known as Strong’s Mountain Camp was hit by a slide that wiped out two gangs of tunnelers working Tunnels 11 and 12 as well as a gang of culvert men. Avalanches aside, camps in these violent weather conditions offered workers little respite from a day on the rail head.

  * * *

  Caption 11...Eadward Muybridge, a prominent English photographer, documented some of the brilliant engineering and displays of brute strength along the Central Pacific line.

  * * *

  Crews of workers drove spikes into the solid granite and used black powder to blast their way through—inch by inch. One of the most impressive feats of engineering was Tunnel 6, which bored its way through the Sierra Nevada Mountains. Four teams stepped up to that task; one at the east and west sides, and one going each way out from the middle—accessible by a vertical shaft. Engineers were so accurate they discovered the tunnel was off by only two inches when the east and west tunnels converged and broke through.

  * * *

  Caption 12...End of the track near Humbolt River Canyon, Nevada, 1868. The Central Pacific campsite and train are at the foot of the mountains.

  * * *

  The first train arrived in Cheyenne in September of 1867 but nearby Laramie—a mere 50 miles away—didn’t see the Union Pacific crew come through until May of 1868. Cheyenne was a stopping point for Union Pacific workers as engineers tackled one of the biggest challenges the railroad would face—the Dale Creek Trestle. The winter of 1867-68 was spent constructing what, at the time, was the highest railroad bridge in the world.

  * * *

  The federal government needed to protect the rail, track-layers, and the burgeoning tent towns along the line. Fort Sanders, south of Laramie, was already in existence before the Union Pacific came through. At Cheyenne, though, Fort D.A. Russell was built with the specific purpose of protecting the railroad. The forts provided security from Indian attacks but many of the “hell-on-wheels” towns—an apt nickname for those popping up along the railhead—needed protection from themselves. The first mayor in Laramie stepped down after just three weeks because he saw the town as “ungovernable,” leaving law and order to be doled out by vigilantes and through lynchings.

  * * *

  Caption 13...City of Cheyenne, Wyoming, 1876. Showing growth of a tent city along the Transcontinental line.

  Caption 14...Rock River train depot, Albany County, Wyoming, 1900. Showing growth of one of the stops along the Union Pacific portion of the Transcontinental rail line by Laramie.

  Press representatives in an excursion party to 100th meridian, 275 miles west of Omaha, Nebraska, to meet with Eastern capitalists and other prominent figures. October, 1866.

  Caption 15...Example of an early Central Pacific locomotive for the US Military. Rail transport was critical during the Civil War.

  Caption 16...Union Pacific #119. The locomotive that touched noses with Central Pacific’s #60 ‘Jupiter’ in Promontory, Utah, at the Golden Spike ceremony.

  Caption 17...Union Pacific directors on the 100th meridian awaiting the arrival of the excursion party of press reps and business men.

  Caption 17b...Union Pacific directors on the 100th meridian awaiting the arrival of the excursion party of press reps and business men.

  * * *

  Central Pacific’s ‘Jupiter’ (one of the two locomotives in the famous picture three pages ahead) was actually a standby. The initial choice—Diamond Stack #29 ‘Antelope’—was being towed to the ceremony by Jupiter when log-cutters mistakenly rolled a large log down a hill, striking the Antelope.

  * * *

  The Jupiter was a 4-4-0 steam locomotive built in September, 1868 by Schenectady Locomotive Works. It was then dismantled and sent by river barge to the Central Pacific headquarters in Sacramento. It’s inaugural run was March 20th, 1869.

  * * *

  Caption 18...Sign posted shortly after the 10-mile record was set.

  * * *

  Eight Irish track layers—Michael Shay, Patrick Joyce, Michael Kennedy, Thomas Dailey, George Wyatt, Michael Sullivan, Edward Kieleen, and Fred McNamara—stepped up to the challenge laid out by the boastful Central Pacific promoter, Charlie Crocker. That seemingly impossible goal was to complete the railroad’s last 700 mile advance to Promontory, Utah by laying ten miles of track in a single day. Two years earlier the crew would have been lucky to put one mile down a day. Years of constant laying, though, had transformed the process into a near exact science.

  * * *

  On April 28th, 1869, sixteen cars of material—bolts, rails, spikes—were unloaded in eight minutes. The hardware was piled onto small railcars by six-man teams and then each car was pulled up the line by two horses and unloaded by crews of Chinese laborers. Three men aligned the wood ties to the surveyor stakes. The work was then on the backs of the eight Irish track layers—who set out each rail, hammered the eight spikes, and bolted the fishplate at the joint. Behind them, levellers lifted ties and shoveled dirt under to ensure the track was level. The gang laid 144 feet of track a minute. 3,524 rails, 28,160 spikes, 25,800 ties and 12 hours later the job was done. Each of the men had hefted 1800 rails; the eight men combined had moved two million pounds of track in half a day.

  * * *

  Surprisingly, the ceremony to drive the last spike (photo on next page) was not supposed to take place when and where it did. The Union Pacific and Central Pacific were racing to lay the most rail and, as a result, they converged in the undesirable Promontory, Utah, at a time when the promoters, key businessmen, and government officials could not attend the event. On May 10th, 1869, Leland Stanford of the Central Pacific and Union Pacific’s Thomas Durant each awkwardly swung the ceremonial hammer at the last spike—and missed. Two swings later the two groups performed a champagne toast in front of their representative locomotives—the #119 from Union Pacific and Central Pacific’s #60 Jupiter. Contrary to popular belief, the last “golden” spike was actually one of five that day, and the only spike that was actually driven into the tie was of the plain iron variety. The other four spikes—two solid gold, one solid silver, and one made of iron with silver on the shaft and gold plating on the head—were temporarily placed into pre-drilled holes in a laurelwood tie that was later cut up and distributed to important figures in business and the government. All five spikes currently reside in museums around the country.

  * * *

  Caption 19...The Golden Spike ceremony.

  Biography

  *The following information was pieced together from Jessup’s obituary, used book listings on the internet, and a brief paragraph from the second edition of Twentieth Century Western Writers –
which was then removed from later editions.

  Richard Jessup (01/01/1925 – 10/27/1982) was born in Savannah, Georgia and died in Nokomis, Florida. He lived in and out of orphanages until age sixteen – when he ran away to join the United States Merchant Marine. In eleven years of seamanship, he claimed he read a book a day and learned to write by typing out the complete text of War and Peace and editing out the errors – he subsequently threw the edited work in the ocean. Jessup was married to Vera in 1944 and had a daughter named Marina. He left the Merchant Marine in 1948 to become a fulltime author. He was at the typewriter ten hours a day.

  Jessup’s obituary claims he wrote over sixty novels (although I was only able to confirm a bibliography of thirty-four). His first novel, The Cunning and the Haunted, was published in 1954 and filmed as The Young Don’t Cry in 1957. Three other novels were also adapted to film – The Deadly Duo, Chuka, and The Cincinnati Kid. He sold the movie rights to the 1971 novel Foxway but it was never filmed. Jessup published eleven novels – primarily westerns and spy thrillers – as Richard Telfair. His last novel, Threat, was published in 1981.

  Bibliography

  *Jessup’s obituary claims he wrote under multiple pseudonyms and published over sixty novels. At this time we can only confirm the pseudonym Richard Telfair and the existence of thirty-four published novels.

  Written as Richard Jessup

  1954 – The Cunning and the Haunted (The Young Don’t Cry)

  1955 – A Rage to Die

  1956 – Cry Passion

  1957 – Cheyenne Saturday

  1957 – Comanche Vengeance

  1958 – Long Ride West

  1958 – Lowdown

  1958 – Texas Outlaw

  1959 – The Deadly Duo

  1959 – The Man in Charge

  1960 – Sabadilla

  1960 – Night Boat to Paris

  1961 – Chuka

  1961 – Port Angelique

  1961 – Wolf Cop

  1963 – The Cincinnati Kid

  1967 – The Recreation Hall

  1969 – Sailor

  1970 – A Quiet Voyage Home

  1971 – Foxway

  1974 – The Hot Blue Sea

  1981 – Threat

  Written as Richard Telfair

  1958 – Day of the Gun

  1958 – Wyoming Jones

  1959 – The Bloody Medallion

  1959 – The Corpse that Talked

  1959 – The Secret of Apache Canyon

  1959 – Wyoming Jones for Hire

  1960 – Scream Bloody Murder

  1960 – Sundance

  1961 – Good Luck, Sucker

  1961 –The Slavers

  1962 – Target for Tonight

  Film Adaptations

  1957 – The Young Don’t Cry

  1962 – Deadly Duo

  1965 – The Cincinnati Kid

  1967 - Chuka

  Other Empty-Grave Releases

  (As of November 2011)

  Richard Jessup

  The Cincinnati Kid - Tango Edition

  CHUKA - Vanilla Edition

  Richard Jessup writing as Richard Telfair

  The Bloody Medallion - Vanilla Edition

  Table of Contents

  Inside Flap

  Copyright

  Editor's Note

  Chapter 1

  Chapter 2

  Chapter 3

  Chapter 4

  Chapter 5

  Chapter 6

  Chapter 7

  Chapter 8

  Chapter 9

  Chapter 10

  Photo-History

  Biography

  Bibliography

  Written as Richard Jessup

  Written as Richard Telfair

  Film Adaptations

  Other Empty-Grave Releases

 

 

 


‹ Prev